Philips Oneblade extension handle/back shaver(Beta, Updated)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Made this to replace my inferior manscape back shaver with the excellent Philips oneblade
- Rating
- 5 / 5
- Likes
- 37
- Downloads
- 436
- Makes
- 2
- Views
- 2,608
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial
General description:
The oneblade fits into one end and is held in place securely by the cap which snaps into place.
A button in the cap allows power button access, and every is printable in a <200mm^3 print volume.
I used a 3D scan of the Philips OneBlade QP2724 from my Miraco Plus to create the handle pocket. The pocket is offset slightly for a perfect fit.
Why I designed this:
I designed this to extend the reach of my oneblade for back-shaving. I've been planning to design this for some time, but the contest finally got it into the head of the que.
Printing notes:
- Layer height: .2
- Recommended Material: ABS/ASA, PETG, PC
- Supports: Bed only, Organic. Paint peg end of angled section for best fit.
- Infill: 25% triangular
- Walls: 3
- Other Modifiers: Print vertically with a brim for best results
- Material Quantity: ≈200grams
Assembly Notes:
- For my printer(Qidi Plus4) slip fit was sufficient except for the handle, which required a few drops of superglue. E3000 also works very well for this.
- Slide all parts together except the cap.
- If parts are too tight, sand as needed for a tight fit or adjust your horizontal compensation settings/flow.
- If parts are too loose, apply superglue or E3000, or adjust horizontal compensation settings/flow.
- Install the oneblade in the pocket of Body Clamp, then install the cap.
There is a button for the power switch which may need to be broken free, depending on your printer.
Cautions and updates:
Update 6/16/25*
After finally getting to print this design, the clearances are too snug with PETG on the Qidi 4Plus. I will be updating the design this week to be more user friendly. As-is the pieces split during assembly. The assembly is still functional, but not as refined as I would like.
Update 6/18/25*
I've added a second, rev 2 folder with increased clearance along all mating faces. I will print as soon as I am able, but expect a drop of superglue to be required for the handle joints for this rev.
Update 6/19/25*
The new offset works perf for the body pocket. Some of the joints are still stiff to assemble, but i think it’s a support issue. I’m re-printing all the pieces upright to minimize sagging and support usage and will update. This increases print time from around 7 hours to just over 10.