Dyson Airwrap display stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other Fashion Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Printed parts:
- Bottom Plate Left x 1 Pc
- Bottom Plate Right x 1 Pc
- Rear Plate x 1 Pc (There are two versions, smooth and V1 with a sun shape on the back.)
- Top Plate Left x 1 Pc
- Top Plate Right x 1 Pc
- Side Left x 1 Pc
- Side Right x 1 Pc
- Supports x 2 Pc
- Plugs x 4 Pc
- Leg x 4 Pc
Filament
Around 800 grams of filament when printing whit 20% infill.
Required other than printed parts:
- M3x5mm heat-set Inserts x 18 Pc
- M3x8mm screws x 8 Pc
- M3x10mm screw x 10 Pc
Print tips:
Top Plates Print upside down, No supports inside accessory slots.
Side supports Print vertically at a 45 degree angle as shown in the picture.
Heat-set inserts
Insert the threaded inserts in the correct places using a soldering iron.
4 threaded inserts in back plate
5 threaded inserts in bottom plate
1 threaded insert in top plate
4 threaded inserts in suports
4 threaded inserts in side supports
Assembly
Support
If you like this or any of my other models consider buying me a coffee.
This is the first model I designed and published. I just started learning to design and print. If there is anything that is not understood or unclear. Feel free to contact me. I would be very happy to receive comments for improvement.