Supportless Stairs for 32mm (DND / TTRPG)

I decided to remix these out of my terrain collection and into their own post for easier find-ability - I've added some new variants as well to help make this more of an original collection. These are stairs for DND and other TTRPGs with a few different configurations. They're sized to 63mm in height total and each step has a 5mm gap underneath so a minifigs baseplate can slide in. I also added thin variants where the steps are 30mm wide instead of 50mm.

Models in this collection:

• T-Stair (Textured and untextured w/ holes for 3mm baseplates in the steps so minis can kinda climb up - the tolerance isn't great so it may need some trimming in some areas - print on the back and you won't need supports)
• L-Stair - A variant of the T-stairs with only one set of steps, this was done in onshape so no textures. The holes in the steps at 4mm so there is a bit more clearance for minis! Step files included! Print on its back for no supports needed.
• T-Stair v2 - Same as the above but T-Style, bigger holes and things. Step files included! Print on its back for no supports.
• S-Stair thick and thin - straight stairs with a thick (12mm) and thin (6mm) back support - same as the others you can print on their side and no supports needed
• U-Stair - These double back on themselves

All stairs are set to go up 60mm + 3mm for flooring and which leaves room for an at scale ~12ft difference between levels (or 1d6 fall damage if the player falls).

All of these models are Support-less if printed in the correct orientation with the exception of the U-Stair which may need some supports on the bottom step.

Category: Games