Thornmaw - low hardware nerf blaster
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Thornmaw is a single shot low hardware nerf blaster.
- Rating
- 0 / 5
- Likes
- 27
- Downloads
- 72
- Makes
- 0
- Views
- 1,590
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Update: 2025-06-06:
Added pre-configured individual parts per request.
Note! TriggerString.3mf does not slice properly in PrusaSlicer use OrcaSlicer instead.
--------------------
Thornmaw is a single shot low hardware nerf blaster.
It is designed to fit the smaller 18x18cm build plate printers.
Even though it is a low hardware blaster there are some none printed parts needed.
O-Ring OD=25mm CS=2.5mm, same is in the XShot micro version 1 (not the new one) or some TPU filament
Spring from a XShot micro version 1 (not the new one) or 30cm of 4mm elastic coord
For best performance use an O-ring.
I recommend using the .3mf files for your slicer. However there is pre-configured individual files as well.
There is a fuzzy skin version available for OrcaSlicer users (that is the version in the pictures). This is not available for BambuStudio due to bug/limitation in the slicer.
There is also no prusa slicer .3mf at all this is also due to limitations in the slicer. For instance it is not possible to set vase mode for one plate in prusa slicer which is required for this build. There are however individual files for each part, just note that TriggerString.3mf do not slice properly in PrusaSlicer so use OrcaSlicer instead.
Assembly guide is available here: