1 / 1
DIY switchable magnet
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
Switchable Magnet.
Center: 17.5mm turned down from .75" all thread
Outer bars: 3/8 (9.5mm)
Magnets: N42 10x5
This is a tad different than the design created by Andrew Klein. It is smaller, the outer "bars" go all the way through, and only the top magnets rotate.
Printed on cetus3d in PLA with 20% infil and .2mm layers
Print instructions
test was printed 0.2mm layer in PLA on cetus3d 20% infill