1 / 6
Samla chamber 11/22l
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fan module for Samla 11/22l
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 11
- Makes
- 0
- Views
- 353
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
I use it for acetone smoothing
print from PETG/PA
DO NOT PRINT FROM PLA/ABS/ASA
floor thingy (for 22l samla) you must cut yourself in slicer
print also clips for lid, as acetone tends to be scared and run away
also beware of condensing of acetone at bottom of a lid and then dropping into your precious prints
BIM:
4-18x heat set insert M3 (
4-18x M3 bolt
2x 60x60x15 fan
completing:
put fans in place blowing down, fasten as nessessary
i use 5V fans and power bank
module should sit firm in both 11l and 22l samla, if unsure, you can add inserts in holes in wall and bolt it to box