1 / 3
Gladiator NXT Desk Clamp (350mm bed needed)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Clamp for the Gladiator NXT flight stick to get it lowered from the table edge while still having full range of motion.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 10
- Makes
- 0
- Views
- 112
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Print in something stiff. I printed mine in ABS-GF25 but I suspect ABS/ASA or even PLA will be fine.
The clamp uses a M5 heat insert on the inside of the clamp jaw. Use a bolt to pull the heat insert back down into the hole (You can't use a normal heat insert iron to push it down, there's no room).
The ‘Shim’ part is for putting between the table and the clamp so the screw won't mark the table. I've attached mine using tape inside the clamp jaw… Not pretty but it works :)