Kickstand for Kingsong S18 side panel and fairing replacement
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Kingsong S18 EUC kickstand for fairing replacement
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 55
- Makes
- 1
- Views
- 404
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
This isn't quite a remix, but this is a kickstand specifically for use with this fairing replacement kit.
It utilizes the geometry of the fairings and the included m4 attachment points.
I used 2x 8mm m4 threaded inserts in the rod, 2x m4x12 screws to attach the kickstand to the rod that goes between, and 6x m4x8mm screws to attach to the attachment points.
Though for the rod, you could likely get away with using the m4 threaded inserts and m4 screws that are already used elsewhere for this kit.
I printed the main kickstand in 95a TPU with 12 walls, tops, and bottoms, with 25% infill. And printed the rod in PETG with 10 walls, tops, and bottoms, with 25% infill. Both would likely be able to be printed with less material, but I wanted to make sure it was sturdy.
The main kickstand, which I printed in tpu, will likely need supports as there are long holes through it for the screws.