Zoom Phone Tripod
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This collapsible tripod for your phone will handle all of your Zooming needs. It's easy to print, requires no supports…
- Rating
- 4.647 / 5
- Likes
- 170
- Downloads
- 929
- Makes
- 23
- Views
- 6,761
- Reviews
- 17
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Share Alike
This collapsible tripod for your phone will handle all of your Zooming needs. It's easy to print, requires no supports and no additional parts.
Features:
-The three legs simply snap into sockets in the tripod base
-A screw ring is use to set the leg angle anywhere from collapsed to fully open
-The threaded post, when fully extended, can tilt forward and backwards by 30 degrees. When stowed in the base, it can be held in place by a clip on one of the legs.
-The screw knob at the top both clamps your phone in place between the jaws and also sets the friction level for tilting forward and backwards.
-Both jaws and the leg with the clip have tiny break-away support structures built-in. No need to turn on your slicer's supports. Just print as-in and break away.
Print one of each part except for print two of the plain legs. Assembly is straightforward - just use the photos as a guide.
Print Settings
Printer Brand:
MakerGear
Printer:
MakerGear M2
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2mm
Infill:
20%
Filament:
Inland PLA
Notes:
The leg with the clip and the jaws all have tiny built-in support structures with clearances that require slicing with exactly 0.2mm layer height. Just break away these small pieces after printing.
Category: Mobile Phone