Greaseweazle v4.1 3.5 Inch Disk Drive Enclosure
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Enclosure for the Greaseweazle v4.1 and a 3.5 inch floppy drive
- Rating
- 5 / 5
- Likes
- 33
- Downloads
- 329
- Makes
- 2
- Views
- 1,525
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Video Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an enclosure for the v4.1 Greaseweazle and a 3.5 inch floppy disk drive. This only works with the 4.1 greaseweazle board.
Requires 4 m3 x 12mm screws to hold the drive into the enclosure and 2 m3 x 8mm to attach the back cover on the enclosure (though you can probably use 12mm ones there too). And 2 m2.5 x 6mm screws will hold the pcb into the back of the enclosure.
There should be enough room below the floppy drive to stuff the excess ribbon cable.
Print settings:
Print enclosure with the front face down on the bed as shown in the photos.