Rainy Sprinkler nozzle 8mm pneumatic
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Sprinkler for rain alike irrigation using 8mm pneumatic system
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 55
- Makes
- 0
- Views
- 272
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
I love these 8mm pneumatic irrigation systems but If you go on Amazon etc you can only find small micro drop things or spray nozzles which only produce a fine dust which is easily blown away by any wind. So I made this one. It. prints in 10 minutes using
PETG, 100% Infill, ≈3 lines brim, no support, and 0.10mm layer height.
print standing with the ball on top and the water inlet at the bottom
Just heat up the tube with some hot water and push it over this thing. It produces a good amount of spray much like normal rain. I would recommend facing it up over for example a vegetable bed. It covers roughly 1m^2 and it’s just like normal rain so it doesn’t bother about light wind.