1 / 2
Ikea LILLABO minimal ambulance rear
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple ambulance rear side for Ikea's LILLABO toy car base. Compatible with existing car and truck front pieces.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 15
- Makes
- 0
- Views
- 73
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Vehicles
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple ambulance rear side for Ikea's LILLABO toy car base. Compatible with existing car and truck front pieces. Shown together with the car front.
Instructions
- Print the piece as oriented with pegs (a model without pegs has been provided if you already have some from other printings)
- Attach the pegs to the slots (you may need some force to get them to snap into place; a metal dowel or needlenose pliers should help)
- Snap the piece into place on the LILLABO base (attach this rear piece last after any front piece); note that a chevron on the bottom points to the front of the car
- Sometimes if the base slot is too tight the pegs can pop up; press them back into place
Recommended Print Settings
- 0.4mm nozzle
- 0.2mm layer height
- 10% infill
- No supports
- Any filament that isn't flexible
- Print as oriented
Other Pieces
The full collection of pieces in this set includes:
- Car front
- Semi-truck front
- Construction vehicle front
- Concrete mixer rear (remix)
- Dump truck rear
- Pickup truck rear
- Ambulance rear (you are here)
Acknowledgements
The car model used in the photos is by @IL3D.