Plus4 Slanted PEI Wiper
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Corrected Screw Holes and Overall Geometry to Reduce Wobble
- Rating
- 5 / 5
- Likes
- 13
- Downloads
- 78
- Makes
- 1
- Views
- 297
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I printed Stew's version and noticed the holes didn't quite line up to the stock Plus4 purge bucket assembly. The printed part was also quite wobbly and had very loose clearances with a well tuned machine. I noticed a lot of the printed part wanting to shift front, back, left, and right instead of squishing down the springs and working properly.
The .STL file is correctly oriented for printing and the .STEP is provided
Install is the same as Stew's, just print and remove the old pei carefully and stick onto this one after install.
THIS REQUIRES A WELL TUNED PRINTER OR ELSE IT MAY BIND
Highly suggest running an extrusion multiplier test, pressure advance, as well as material shrinkage and machine skew.
Some starting values for ABS/ASA (Highly suggest tuning for your printer as these values can change)
XY Shrinkage: 99.8%
Extrusion Multiplier (Flow Ratio):
Stock QIDI Plus4: 0.92
Most other printers: 0.94- 0.95
Pressure Advance PLUS4: 0.025
Extrusion Multiplier, and Pressure Advance can be tuned within most slicers like ORCA
More info:
https://ellis3dp.com/Print-Tuning-Guide/articles/index_tuning.html
Skew and Material Shrinkage can be tuned using these resources below
https://vector3d.shop/products/califlower-calibration-tool-mk2
https://www.printables.com/model/778188-calistar-parametric-open-source-alternative-to-cal