Shokz Joint Brace
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Quick fix to hold over a pair of Shokz that inevitably broke just weeks after the warranty was up.
- Rating
- 4 / 5
- Likes
- 19
- Downloads
- 396
- Makes
- 0
- Views
- 1,330
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial
I made this quick brace to keep my family member's Shokz usable. They ended up breaking just at the joint between the neck band and then electronics behind the ear like a lot of these units do. However, his broke just weeks after the warranty ended so hopefully this will hold him over to a new pair.
I designed this in just a couple of minutes and have no promises that it will help your pair, but I figured I would post it here in the case someone is in a similar situation and wanted to give it a try. The holes for the small screws are 1.3mm in diameter, so find a short set of screws just above that at 1.4mm or something similar. Knowing what I do now, I would make this fully 3d-printed and clipping into place, but at the time I wanted to test different variations easily, so that's why I secured the brace with screws.
I made a small short about it if you want to check it out (it was one of the first shorts I tried to make, sorry if it is tough to watch haha)
Good luck and happy printing!