Magnetic sheath for Kuhn-Rikon Paring Knife
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Goal was to make a magnetic sheath for a Kuhn-Rikon paring knife with a 10cm blade.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 11
- Makes
- 0
- Views
- 73
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Public Domain
Goal was to make a magnetic sheath for a 10cm “colori” paring knife from Kuhn-Rikon. We lost the original sheath, and we were carrying the knife with a cork jammed on the tip so it wouldn't poke holes in the picnic bag.
The design uses 6mm x 1.7mm magnets. Magnets are weak in shear, so the sheath has a little post at one end to prevent it from just sliding off.
The v6 model (shown in the photo) has four magnets that followed the midline of the blade. The v7 model has five magnets aligned with the flat of the blade, so that the knife doesn't rock back and forth on the short axis, but the sheath doesn't seem to hold on to the knife blade as well as the v6 model.
To design the sheath, I took a photo of the knife on a cutting mat with a half-inch grid pattern. I imported the photo into Fusion, then scaled the photo to the size of the grid. This made it easier to trace the outline of the blade with splines. I've included the gnarly poorly-constrained Fusion file so you can make edits.