1 / 4
Prusa MK3/MK3S/MK3S+ Einsy Rambo and RPi4 Box Remix — image 1
1 / 4

Prusa MK3/MK3S/MK3S+ Einsy Rambo and RPi4 Box Remix

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Replaces the electronics box with one that also holds a Raspberry Pi 4B for things like Klipper or Octoprint

Rating
0 / 5
Likes
11
Downloads
32
Makes
0
Views
313
Reviews
0

Updated at source:

Model information

License
GNU General Public License v2.0

This is basically the same as the original, but includes a cutout in the door for the X-axis motor cable strain relief, and better aesthetics. 

Previously, either the heatbed or X-axis cable had to run through the bottom of the case and was not strain relieved. The rear strain relief is for the heatbed, and the door strain relief is for the X-axis.

I've also included mirrored parts for the door hinges and heatbed strain relief that are not in the original files. 

To install you need:

  1. One extra door retention screw and square nut available in the spare parts bag. 
  2. Drill out the mounting holes in the RPi to clear M3 hardware. You can alternatively use smaller hardware.
  3. A right-hand adapter for the RPi USB-C port for power. I used https://www.amazon.com/dp/B0CTDNBZ5S and make sure you install it before mounting the RPi.

Before starting, raise your X axis to the stops. You will need plenty of room to clear the door when assembling and turning the rods by hand is a pain.

I recommend mounting the RPi to the box, then the box to the frame, then the Einsy board. See pictures for how I ran the cabling. Use a ziptie to clear the cables from the GPIO header so vibrations don't damage any insulation and create a short. I put some adhesive felt onto the extrusion behind the box to prevent printer vibration creating noise. 

Print using a 0.2mm preset in PETG.

7-July 25 Update: added a version of the door with a cutout for a Cherry-sized keyboard switch. I mounted this as a power on/off button for the RaspberryPi.