1 / 1
Straw Pencil or Silverware Holder and Drying Rack with Daisy
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Hold whatever will fit vertically. Has lots of ventilation and drainage to avoid mold. Flower is printed separately.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 9
- Makes
- 0
- Views
- 83
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
Basic straw/silverware/pencil/whatever holder with a touch of whismy. Lots of ventilation and drainage and a curved floor to direct liquid down the drain holes. Daisy is printed separately for best chance of success and potential color change and should be glued on. I may make a v2 with a press-fit pin instead but if you don't want to use glue, you could probably just wrap some tape around the pin and it'll press fit.
I've printed it in the following materials:
- PLA: light, good for wall mounting, but VERY delicate and wall layers will separate with too much pressure.
- PETG: heavy, good for leaving on a counter, more durable than PLA but could still separate if you're too rough.
- ABS: very light, good for wall mounting, stronger than both PLA and PETG in my experience.
Recommended settings:
- 2 perimeters all around (3 if you aren't wall-mounting it with double-sided tape)
- 8% gyroid infill (10% if you aren't wall-mounting)
- Tree supports at angles over 40 degrees (holder only, flower didn't need supports)