Blinder holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Share Alike
Two of these small plastic clips hold the blinders down. Good especially if you have the blinders on a door because otherwise the blinders will swing and potentially break.
Naturally this kind of small parts break in due time so here is a new version. Originals where poorly designed to say the least. There is a piccy of original broken one too.
Both sides are symmetric so just 2x print the same part in case old ones are broken.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2.5
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
I used 0.2 layer
Infill:
I recommend adding 100 infill to certain parts. See the slices file .
Filament Material:
PLA
Notes:
PLA will not last well so use ABS instead. I just happened to have PLA so it will last 1-2 years in the sunshine ... maybe...
Category: Replacement Parts