1 / 10
TwinAir filter for CF MOTO 450MT IBEX450 — image 1
1 / 10

TwinAir filter for CF MOTO 450MT IBEX450

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

New version of Airbox cover for the CF Moto 450MT motorcycle, allowing the installation of a TwinAir airfilter.

Rating
5 / 5
Likes
11
Makes
1
Views
1,769
Reviews
1

Updated at source:

Model information

Category
Automotive
License
Standard Digital File License

18.03.2026 Update

  • I made minor cosmetic changes to the top part and increased the distance between the top and bottom parts by 1 mm to extend the lifespan of the TwinAir filter

28.02.2026 Update

  • I have added a new Intake throat_V2 I recommend printing this part instead of the Intake throat_V1

***************************************************************************************************************Hello,
The following project presents an airbox cover for the CF Moto 450MT motorcycle, allowing the installation of a TwinAir filter from the Yamaha Tenere 700. If you ride on gravel roads, the stock filter used in the CF Moto 450MT is too weak—large amounts of dust can get into the airbox, which may lead to engine damage. This design helps to minimize that risk.

This is my original project, so please respect the copyright according to the Creative Commons license.

Print specifications using ASA filament:

Bottom_V2 and Bottom part bottom layers: 7 and top layers: 5

Top_V2 and Top part bottom layers: 6 and top layers: 5

Walls: 4

Infill: 35% cubic for the main plate (TOP), 40% for the frame (BOTTOM)

Required components:

4 pcs M4x5x6 brass threaded inserts

4 pcs M4x16 Torx screws with wide heads

TwinAir filter, part number: 152622FR

Aditional Air filter. 160000YTN2 (you must print Intake throat to instal this aditional cover)

After printing, embed the brass inserts into the base in the four visible mounting posts.
You can also embed two stainless steel M5 washers, as I did (visible in the attached photo), although this step is optional. Next, fit the filter into the frame and fasten the entire assembly using M4 screws. Trim the portion of the filter base that extends beyond the outer frame with a knife, or leave it as is—depending on your preference.

Best regards to everyone!

P.S.

I have added version 2, which differs only by the removal of the sealing ring on the edge of the foam and a 0.5 mm increase in the space between the upper and lower clamping parts of the TwinAir filter.

 

Tags