Updated CoPrint Ender3V3 carriage and backing plate
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Revised carriage and backing plate to run a CoPrint setup on an Ender3V3
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 21
- Makes
- 0
- Views
- 194
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
Loved the original model so I remixed it to add heated inserts to the carriage and backing plate. There wasn't enough meat around the belt mount to put inserts so these remain as threaded into the plastic.
You will also need the locking tabs from the original model, view the linked Creality video for disassembly and reassembly.
I had to use an old LM8UU bearing to drive out the main bearing as it was quite snug in the factory carriage.
You will need an assortment of M3 bolts to fit this up. The two belt mounts will self thread, recommend running the bolt through them to cut the thread before fitting up.
I printed the carriage on it's side with manual tree supports for the belt mount. I printed the backing plate without supports.
I printed in ABS with 25% infill and 4 walls.