1 / 5
Fuse holder for fuse 5x20mm with spring - parametrizable — image 1
1 / 5

Fuse holder for fuse 5x20mm with spring - parametrizable

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A fuse holder for fuse dimension 5x20mm with spring inside

Rating
5 / 5
Likes
4
Downloads
33
Makes
1
Views
182
Reviews
1

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

Warning: This is only for low voltages.

 

Fuse holder for fuse 5x20mm with spring from ball point pen.

For size changes you can change the parameters in fusion360.

If you enjoy the project, please leave me a like or post a make.

 

Assembling instructions:

Ill qoute the original maker: push each (stripped) wire end into its respective part (housing and cap), and twist the wire ends into “knots” so the wires cannot be pulled back out. Insert spring and fuse, and push the cap onto the housing and twist about a quarter turn to lock it in.

 

Printing instructions:

I used a 0.6 mm nozzle for all parts. Just ensure that your slicer can print “thin walls” or line width thinner, e.g. 0.4 mm.

  • PETG will do best
  • 0.15 mm layer height
  • 2 wall lines
  • no support, no brim