Heart shaped rose, 2 versions
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A small rose in the shape of a heart that is printed in vase mode.
- Rating
- 5 / 5
- Likes
- 87
- Downloads
- 539
- Makes
- 8
- Views
- 1,692
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial
Saw the spiral rose vase by lytta and was inspired to make a small heart-shaped rose. I'm still learning Fusion 360 so this was made in it, though I probably took the worst way of modeling it, you don't want to see my timeline.
It's about 40mm high, has a base of .6mm high, and i have not tried scaling it yet.
Prints in vase mode, slowly. Printed in clear PLA because I was testing new filament.
It prints at .2mm layer height. I changed print speed down to 35mm/s from 50mm/s, and just in case, increased minimum layer time to 20 secs, I don't know if that one made a difference. Slicer settings will vary for everyone. Printed in about 1 hour, and sliced using Cura.
In my case, I could not print the gcode from a SD card, I had to use octoprint and print over wifi. Printing from a SD card resulted in intermittent extrusions that looked like dots.
Added Rose Version 2 that's more symmetrical looking if that's what you like. It's about 80 mm L x 77mm W x 60mm H. Labeled RoseV2. I scaled my print down to about 40mm for the picture.