1 / 4
M4/M16/STANAG magazine shaped BB reservoir for Airsoft — image 1
1 / 4

M4/M16/STANAG magazine shaped BB reservoir for Airsoft

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

M4/M16/STANAG magazine shaped BB reservoir for Airsoft

Rating
0 / 5
Likes
1
Downloads
8
Makes
0
Views
200
Reviews
0

Updated at source:

Model information

Category
Other Sports
License
Creative Commons — Attribution

This reservoir for Airsoft BBs is shaped like the typical M4/M16/STANAG magazines and can fit into normal mag-pouches.
I use it for refilling my Hicap magazine on the field.

Consits out of two parts --> main housing and lid
I recommend to print the main housing on the angled bottom surface (see screenshot).
By this you increase the strength of the whole part. The main housing has a small 1mm thick protrusion which is used for better support and can be easily removed after the print.

During the initial mounting of the lid, you need to use more force until it is jumping over the recess in the housing. Later you only pull back the lid by ~2cm as seen in the picture. I added silicone grease to the sliding surface, which significantly improved the ergnomics.

This design was a lot of work, so if it gives you value in your Airsoft game, it would make me very happy, if you would consider a tiny contribution to my Paypal. It would be well appreciated. :)
--> Paypal.me/KorbiMuster

Tags