1 / 8
Upgrade Parts - Ace Of Spades Nerf Blaster — image 1
1 / 8

Upgrade Parts - Ace Of Spades Nerf Blaster

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

WIP upgrade parts for the Nerf Destiny Ace Of Spades!

Rating
0 / 5
Likes
14
Downloads
63
Makes
0
Views
800
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Collection of mods for the Ace Of Spades LMTD Nerf blaster.
 

Replacement Cylinders:

  • No hardware
  • Side-load, front-load, rear-load!
  • Drop-in replacement, no modifications required!

 

WIP Reinforced Swing Arm:

  • Makes the cylinder housing much stronger and less likely to flop around while reloading!
  • Hardware:
    • Kinda forgot lmao
    • Long countersunk bolt, M4x50 I think?
    • Nut for the bolt.
    • Cap for the cylinder housing to rotate in. I think I used some kinda weird nylon flange bearing. Shouldn't be too hard to design a printed one.
    • 20mm Nerf-size coarse screw, to reinforce the RotatorRod.
  • Requires shell cutting as pictured in photos #3 and #4 in the gallery.

 

WIP Cage Guide:

  • Improves accuracy, theoretically.
  • Replaces the inner jam door panel on the left half of the blaster.
  • Requires shell cutting as pictured in photos #5, #,6, and #7 in the gallery.
  • No hardware.

 

Battery Door Grip:

  • With some shell cutting, you can store your battery in the grip!
  • Very small space, but this does work!
  • The printed bar must be cut and sanded by hand to match the existing contours. It's actually pretty easy!

 

Rewire:
I rewired the blaster with standard hobby gauge wiring, battery-in-grip, a hair trigger for the rev, a new rev switch, and Insutanto flywheels! 

The motors are some weird custom thing with no hobby equivalent, so a full rewire would also require some kind of expanded motor housing. 

I created the hair trigger rev by using a linkage rod that locked the jam door when pulling the trigger. The linkage is located above the trigger but under the cylinder, the microswitch location is shown in photo #8 in the gallery. This used a hobby standard 10A microswitch with a lever. 

The wiring to the grip was routed above the cylinder and through the path of the pusher components above the grip. The microswitch was wired at one of the motor connections so that it didn't have to route back to the battery.

Tags