Bottlejack graphics card support - short
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A support for your graphics card in the form of a stylized bottle jack with three different size centers. 4 cm to 10.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 123
- Makes
- 0
- Views
- 332
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
I wanted a support for my graphics card because it was noticeably sagging. All I could find on here where longer versions, which would not fit my case. I needed something shorter.
My version resembles a bottle jack, because there were so many already looking like jack stands.
The project file include three different lengths of the ‘screw' centers:
- The shortest is for 4-6 cm
- The middle is for 6-8 cm
- The longest is for 8-10 cm
Just delete the ones you don't need. If you would like me to make an even longer center, that is quite easy to do, just leave a comment!
====================================================================
Printing:
All settings are included in the 3MF project file!
Recommendations:
- 0.15 structural
- 20% fill, Gyroid pattern
- Supports only for the curved part of ‘screw’ centers on the plate.
Filament:
Up to your preference.
On other models I see a lot of recommendations against PLA. My reasoning is, if the inside of your PC gets so hot it deforms PLA you have some major heat problems, which need to be fixed right away!
====================================================================
As you can see, I learned some new OnShape tricks. I thought I would include them for you all :)
Makes and comments are always appreciated!! Would love to see a picture of this support in your rig!