Umbreon (Multipart) for non-MMU printers

The photos of the finalized print were taken prior to adjusting the tolerances, so quality and fit may vary. I will include the original STLs from the model I remixed; however, I caution against using them as-is since their orientation isn't flat to the print bed. Additionally, because I used the original model for my print, it required a significant amount of sanding. To help minimize or eliminate post-print sanding, I offset the ring inserts by 1.5 mm on all sides.

I’ve tried to label everything properly, but please pay close attention to the thickness differences between the right and left sides. Make sure to place the rings with the corresponding sizes on the correct sides. Notably, the ring on the back right side protrudes substantially, which is due to the wrong ring being placed on that side.

The ears, tail, and nose were attached with super glue—please ensure their orientation is correct, as incorrect placement may cause some edges to protrude. All other inserts fit with friction, but if needed, super glue should work perfectly.

This model was printed with a 6 mm nozzle; using a smaller nozzle could help improve tolerance issues experienced.

The body requires supports; I used normal tree supports. I will include a photo of my support settings. Additionally, I’ll provide a .3mf file for parts that can be printed together.

***Also I discovered the rings fit pretty tightly even after the repairs to the model so I added looser fitting STLs that can be used if you run into any fit problems.***

Feel free to reach out or leave a comment if you have any questions.