Manta E3EZ Stepper Driver & CB1 Fan Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3x 4010 Fan Mount for the up to 5 stepper drivers and the integrated CB1.
- Rating
- 5 / 5
- Likes
- 4
- Downloads
- 40
- Makes
- 2
- Views
- 188
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
Mounts 3 4010 fans, 2 above the stepper drivers, 1 for the CB1
HW required:
4010 fans x3
M3 35mm x4 (for mounting the bracket)
M3 10mm x6 (for mounting the fans)
M3 Nuts x6 (for mounting the fans)
I used Winsinn 40mm 24v 8500RPM Fans ( https://www.amazon.com/dp/B0DJQVML4N )
Print out of PETG or any other filament with a decently high melting point. I printed out of ASA for convenience.
Connect CB1 fan to MFan
Connect Stepper fan to fan0/fan1/fan2 (PA8,PB15,PB14).
Add the following to your Klipper config:
[multi_pin tmc2209fans_pins]
pins: PB15, PB14 #depending on which fan ports you use
[controller_fan tmc2209fans]
pin: multi_pin:tmc2209fans_pins
kick_start_time: 0.5
fan_speed: 1.0
idle_timeout: 120 # Keep running for 30 seconds after stepper stops
stepper: stepper_x, stepper_y, stepper_z, stepper_z1, stepper_z2
This will tell Klipper to turn the fans on when the steppers are engaged.