Dyson Accessory Mounts
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A variety of mounts for Dyson vaccums. These should fit v7/v8/v10/v11 at least, and maybe others.
- Rating
- 4.942 / 5
- Likes
- 380
- Downloads
- 2,028
- Makes
- 66
- Views
- 8,623
- Reviews
- 52
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
Source / Attribution:
These are remixed from https://www.thingiverse.com/thing:2860289. I wanted to clean up the F3D file so I could follow it and create some additional mounts. Having done that, it makes sense to release my updates back to the community. I've printed a few of these, and they fit well.
Included Files:
I've included the F3D file and the STLs. They should be oriented in printable position. There's also a 3mf file that gives suggested print and support settings in PrusaSlicer. While it shows a couple mounts, the suggestions should work for all of them.
Note: The “v” suffixes are from the Fusion 360 file version, not the Dyson vacuum version!
Print Settings:
- PLA works, PETG would be fine
- 2-4 perimeters, recommend at least 3 for the “Extra Wide” form factor.
- 15% infill, grid or gyroid
- 0.2mm layer height (untested at 0.3mm, but may work)
- .55mm external perimeter width
- .5mm internal perimeter width
- No gap fill
- PrusaSlicer snug supports
- The notches in the receiving sections do not need supports
Compatible Dyson Models:
- v7
- v8
- v10
- v11
- v15
- Gen5 Detect vacuum wall mount