Pentacon Six to Mamiya 645 waist level viewfinder adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This model allows using a Pentacon Six waist level viewfinder on a Mamiya 645 (normal or 1000s).
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 31
- Makes
- 0
- Views
- 448
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial
So, I bought a Mamiya 645 1000s with a prism finder. I was soon flabbergasted by the fact that a waist level viewfinder costs nearly 200€: Almost as much as a M645 body without a lens.
The thing with waist level viewfinders is that they are just folding metal boxes with magnifiers. Pentacon Six waist level viewfinder can be found for as low as 30€ in Europe. I already had one, so I figured I'd see if I can adapt it to the Mamiya.
Turns out I can. I used pserey's non-folding plastic waist level viewfinder as a base and added the following features:
- Tabs that can be used to lock the adapter on the camera and a cutout for them. A very simple design that is held down by the P6 viewfinder, but should lock even without.
- Some height to accommodate the P6 viewfinder that extends downward when closed, but only just enough to make the magnifier still focus properly on the focusing screen
- Slots for four M2.5 screws that are used as attachment points for the Pentacon Six viewfinder.
Assembly is as follows:
- Print the base. Print it sideways with build plate only tree supports. You can print it with normal supports upside down, but you'll get some ugly surfaces, or you can print it the way it sits on the camera, but then you have to clean a lot of supports. Theoretically it could be split in two and be printed in two non-support pieces, but tree supports were easy enough to clean. The channels for tabs needed a bit more cleaning, but not much.
- Print two tabs. One of them as is, the other mirrored.
- Screw M2.5 5-8mm long screws to the four small screw holes. Leave 2-3mm or so visible. Adjust as needed to get a snug fit for the viewfinder. M2 probably works too, but might need adjustment to the model.
- Place the tabs so that the small identation faces towards the lens and the tab itself is placed as far back as possible.
- Attach P6 waist level viewfinder. Align the screws with the round holes on the viewfinder bottom well and press the viewfinder down. Then push it forward to lock it.
- Attach the adapter to the camera and then push the two tabs forward a bit to lock it.
- Detach by pushing the two tabs back and then lifting the adapter.
Whenever you attach or detach the P6 viewfinder while it is on the camera, I recommend doing it opened. It should not scratch the M645 focusing screen even if it is closed, but it's better to be safe than sorry. Although scratching it would be a great reason to buy a brighter viewfinder I guess.
