YYR Wood Rack Angled Brackets

I got a YYR branded wood rack (likely the same as many others) and wanted to angle it slightly to make sure that round stock would not roll off. These create a 3 degree upward angle. Printed with a few extra perimeters, these should not adversely impact the holding capacity of these (they are WAY beefier than the standoffs used on the BORA racks).

I also included a 7/32 (6mm) drill guide to help center the bolts in the holes. The included lag bolts are likely still long enough for the lower holes, but it does reduce the depth-in-stud by 15mm so you could use longer 5/16 or M8 lag bolts if you are feel compelled.