GEPRC MOZ7 V2 - Edge T3 VTX Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A solution to mount the Edge T3 in the Moz7 V2 with the supplied MIPI Cable.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 10
- Makes
- 0
- Views
- 187
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The MIPI cable supplied with the Edge T3 is too short to fit the T3 Air unit as intended in the Geprc Moz7 v2 frame.
This small bracket is my solution to solve the issue by mounting the VTX further forward.
Run the MIPI cable under the FC stack.
I contacted Edge Smart Drive regarding a longer MIPI cable, but was informed that none are available and that the cables used for Walksnail or DJI are not compatible. (As of July 2025)
Hardware:
2x M2x2 screws
2x M2x8 screws
Support my work: All of my models are available for free. If you'd like to show your appreciation, consider Buying Me A Coffee.
Filament: PLA
