1 / 2
Cleat guard for stainless steel boat cleat — image 1
1 / 2

Cleat guard for stainless steel boat cleat

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Keep lines from tangling on cleat

Rating
0 / 5
Likes
4
Downloads
16
Makes
0
Views
167
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

I have a sailboat.  On the bow are cleats used to tie up the boat.  Jib sheets (lines used to control sails) will tangle on the cleat, requiring someone to go to the front and untangle them.  These guards snap around the cleat and protect them.

These were custom made for my cleats, and probably won't work on any other brand.  The cleats are 12" (300mm) long, with a completely round shape.  The tips are .5" (12mm) diameter, and the inner diameter is .9" (22mm).  If yours are 12" and look like the picture, they should work.

Printing:  I used PLA becuase it is cheap, easy, and was in the printer.  These are used outside (in the sun!) so PLA is a poor choice.  But these are only used when sailing (and have to be taken off to tie up the boat), so they aren't out all the time.  I hope they will last a few years.  PETG or ABS would be better choices.  Print settings aren't overly important – if it stays together, it's good enough!

Assembly:

  • Print a pair.
  • Purchase 3' (1m) of 3mm shock cord (in the US, West stocks it at $1.30/ft).  
  • You will note that each one has a large hole and a small hole.
  • Tie an overhand knot close to the end of the shock cord.
  • Feed it from the the cross hole through the small hole.
  • On the next part, feed from the end, through the large hole and out the side of the cross hole.
  • Set them on the cleat, pull gently tight, pull the cord into the V-notch, and tie an overhand knot (do not use a larger knot – a single overhand knot only!).
  • You can either do the same thing on the other side with another piece of shock cord, or feed the long end over to the other side and keep going.
  • On the V-notch sides, it is important to keep a long tail, because you need to pull on this. 6"/150mm is probably enough.

Use:

  • The knot on the V-notch is a single overhand knot. If it has been pulled tight, it will pass through the hole.  Pull it through and this gives enough slack to place over the cleat.
  • Pull the knot back through the hole, and set it behind the V-notch (ideally, it would hold without a knot – but it doesn't….).  Do the same on the other side.