Corner mount for ZG-204ZM with angle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Corner mount for ZG-204ZM that uses the included ball joint to allow fine angle adjustment.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 27
- Makes
- 0
- Views
- 178
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial
The ZG-204ZM sensor, which supports PIR and mmWave, includes a base with a ball joint that allows for angle adjustment. However, it can only be installed on flat surfaces, and the designs I found online allow corner mounting but sacrifice the ability to adjust the angle.
I designed this corner mount to preserve the angle adjustment, to be printable without supports, to use as little filament as possible, and to hold the sensor securely without any screws or extra hardware—just friction. For extra stability, you can use the double-sided tape that comes with the sensor.
It’s also fully compatible with Command Strips. If you’d like to save strips, you can cut one in half, since the sensor is very lightweight.
I printed it with the small flat face down, directly on the print bed. However, if your printer struggles with that orientation, you can print it on one of the side faces. It will take a bit longer but is more reliable.