Riser stand for the Anova Vacuum Chamber/Sealer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A riser stand that allows the use of small vacuum sealer bags in the deep chamber of the Anova Vacuum Chamber/Sealer.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 10
- Makes
- 0
- Views
- 68
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The Anova Vacuum Chamber/Sealer uses a deep chamber to compensate for its compact size (relative to more traditional chambers). The deep chamber lets larger bags be folded over so that the open end doesn't extend past the sealer bar. Problems arise when trying to seal small bags. The chamber is so deep and the sloped edge of the chamber means small bags can't reach the sealer bar--they slide back into the chamber after attempting to position them on the sealer bar. This riser lets small bags sit more level with the sealer bar. It sits lower than the sealer bar, otherwise the bag and its contents might sit too close to the lid.
The photos show a notch in the corner. The notch is gone. I removed the notch after making the riser smaller to fit the beds of more printers.
I designed this via TinkerCAD. It's a public design, you can find it by searching for the tag “Anova”.
You should be able to print this in just about any type of filament. I used PETG.