Esp32-cam module backplate
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.19 – €0.24 net (excluding VAT)
For file: CE3_esp32cam_backplate.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.22 excluding VAT (range midpoint).
- Weight reported by the author
- 2 g
- Print time reported by the author
- 15 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Back cover for the ESP32-CAM development board to prevent shorts with cutout for power cables
- Rating
- 5 / 5
- Likes
- 6
- Downloads
- 43
- Makes
- 0
- Views
- 288
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
A friction-fit backplate for the ESP32-Cam devboard with a cutout for power cables. It's made to perfectly fit two square female jumper cables for the gnd and 5v pins.
Once you configure the camera to work over wifi, it's nice to have a backplate to prevent an accidental short between the other pins, as I learned the hard way. It's a fast and simple print, and leaves plenty of room between the backplate and microcontroller to facilitate cooling and prevent warping of the backplate from excessive heat. It also doesn't interfere with adding an external antenna on the IPEX connector.