Modification of MinderRC DH50
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Installing a capacitor block in the MinderRC DH50 so that this "miracle" can at least start to weld. :)
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 6
- Makes
- 0
- Views
- 24
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Necessary parts (or their analogues):
- Aluminum Electrolytic Capacitor Panasonic EEUFR1A222L - 10 pieces;
- Screw DIN 912 M2.5x20 - 4 pieces;
- Copper wire Ø1.6 mm - ~0.4-0.5 meters.
P.S.
The photo shows a prototype, and there were no screws of the right size, so it was taped down. I posted a modified version, I didn't bother to rework my spot welding because I was too lazy. :)
P.P.S
I don't see any point in buying MinderRC DH50, because without modification (installation of capacitors) the device welds just terribly, which is "cured" by modification, but at the same time the size (length) of the device increases to 14 cm, which is almost equal to the size of MinderRC DH50 MAX (15 cm). Imho, it is better to immediately take MinderRC DH50 MAX and install capacitors inside the case.