1 / 3
Wet stone sink holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Wet stone holder/vise for use in sink
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 35
- Makes
- 1
- Views
- 265
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
Extra hardware required:
- 3/8" threaded rod (I used 16 thread per inch stainless. stainless is expensive, but is best for the wet application)
- 8 3/8" nuts to match rod (again… 16 tpi stainless)
Printer, material, and settings
- bambu lab A1 with 0.6 mm nozzle
- translucent PETG (better for strength but PLA should work fine given right settings)
- 30% infill with 5 layer perimeters
4 of the nuts are to sure up the sink mounts. However, I cut the rod to a pretty tight fit, so the weren't necessary. There is 0.1" between the bottom of the sink mount rod holes and the face that touches the sink. So the rod will need to be cut at least 0.2" narrower than your sink is.