Walther CCP Belt Clip Magazine Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Walther CCP Belt Clip Magazine Holder with leaf spring retention.
- Rating
- 0 / 5
- Likes
- 1
- Makes
- 0
- Views
- 67
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
Other Belt / MOLLE Clip magazine holders: https://www.printables.com/@brass_ring/collections/2468601
Features:
various sizes and styles to accommodate any magazine capacity
various belt clip lengths to fit different belt widths
for the chamfered outer sleeves, the sleeve height corresponds to the belt clip length
outer sleeves come in TH (through hole) and BH (blind hole) versions - the TH version can be easily disassembled, but the BH is permanently assembled
Printing Recommendations:
All parts are oriented to use seam placement rear.
I use painted on snug supports under the locking tab.

I used a 5mm brim on the outer sleeves to keep them from tipping over - rotating the outer sleeve 180 degrees so that the top is on the build plate should also work
Assembly instructions:
Trim any elephant's foot before assembly to assure proper fitment.
Layout the parts.

Orient the leaf springs so that the bow protrudes inward into the slot in the inner sleeve and slide the top edge of the leaf spring into the small retention groove.



Repeat step 3 for the other side while holding the other spring in place.

Orient the inner sleeve and the outer sleeve so that the belt clip attachment cut outs are on the same side and start sliding the inner sleeve into the outer sleeve so that the leaf springs are partially covered, but the the belt clip attachment cut out is fully exposed.

Place the belt clip into the attachment cut out and slide the inner sleeve fully into the outer sleeve.



Test the function by inserting a magazine.
