1 / 12
Top Filament and PTFE Tube Guide — image 1
1 / 12

Top Filament and PTFE Tube Guide

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A cantilever to guide the filament over the X-axis.

Rating
0 / 5
Likes
1
Downloads
8
Makes
0
Views
162
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Top Filament and PFTE Tube Guide

After I bought a filament dryer, I also had to think about a new way to feed the filament. To do this, I designed this cantilever to guide the filament over the X-axis of my Anycubic Kobra 2 Plus.
The model is available for PC4-M6 and PC4-10 pneumatic connectors.

Update 2025-08-10:
I have added another model to which the runout sensor can be attached, allowing the PTFE hose to be connected directly to the hot end. This model need 2 PC4-M6 pneumatic connetors.

NOTE: Due to the long way, I use a 4mm x 2.5mm PTFE tube. My matt PLA caused problems at this length and was very difficult to pass through the 4mm x 2mm PTFE tube, which had a negative effect on the print.

Fittings

  • 2 PC4-M6 or PC4-M10 pneumatic connectors
  • 1 T-Nut M3 (EU20-M3 ×10×6)
  • 1 M3 x 16mm
  • 2 M3 x 186mm
  • 3 Washer M3

Temperatures, Speed and Materials

  • Filament: PLA
  • Printing speed: 120.0mm/s
  • Perimeter: 3
  • Layer: 0.2mm
  • Infill: 15%
  • Infill pattern: Adaptive cubic
  • Print temperature: 215°C
  • Temperature hotbed: 65°C
  • Brim: No
  • Support: No
     

Approximate Printing Times and Filament Quantities

  • Filament Guide PC4-M6: Time: ~1:11h, ~Quantity: ~25.80gr, ~8.65m
  • Filament Guide PC4-M10: Time: ~1:12h, ~Quantity: ~25.69gr, ~8.62m
  • Filament Guide w/ runout sensor: Time: ~1:34h, ~Quantity: ~30.58gr, 10.25m

Tags