Wyze Cordless Vacuum wall mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A replacement for the original, or an upgrade for the "S" model. Tested on both models.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 93
- Makes
- 0
- Views
- 351
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
General:
Replace a broken wall mount, or add a wall mount for your Model S cordless vacuum.
Why I designed this:
I loved my original Wyze cordless vacuum, so we bought an S for the upstairs as well. We were disappointed to find that it doesn't come with the same type of wall mount that the OG did. So I set to reverse engineering the mount.
Printing notes:
Layer height: .2
Recommended Material: PLA works fine, but ABS/ASA or PETG would probably last longer
Supports: Snug automatic(as shown)
Infill: 15-25% Gyroid or triangle
Walls: 3
Other Modifiers: Print as oriented
Material Quantity: ≈145grams with supports as shown
I printed from PLA on Centauri Carbon at .2 layer height with 15% Triangle infill and 3 walls in 3.5 hours
Notes:
I modified the design slightly from the one pictured after printing this one.
- Removed the fillet on the bottom plate for better printability
- reduce the height of the accessory tab from .12” to .08” because it caused some slight interference
- increased the hole size on the ID of the accessory mounts by .005” for a better slip fit where support remnants made things a bit tight.
_____________________________________________________________________________________________________________
Don’t forget to follow me, post a make, leave a like, or tell me what you don’t like so I can make improvements.
Thanks, and Happy Printing!
Also check out:
Replacement seal for Wyze cordless vacuum: https://www.printables.com/model/1356342-printable-spare-wyze-cordless-vacuum-canister-seal
https://fabtechmfg.square.site/