1 / 3
Ryobi RTS12T Power Cord Storage and Crank Handle Improvement — image 1
1 / 3

Ryobi RTS12T Power Cord Storage and Crank Handle Improvement

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Two bolt-on pieces to wrap power cord around for storage and a small bushing for the crank handle to stop the wobble.

Rating
0 / 5
Likes
1
Downloads
7
Makes
0
Views
52
Reviews
0

Updated at source:

Model information

Category
Organizers
License
Creative Commons — Attribution

I wanted a different way to store the power cord instead of letting it dangle with a cable clip. These pieces use the existing screws and holes in the saw frame. No modifications or extra hardware for mounting. One right side part is a two piece that uses two M3 nuts and M3x8mm screws. This prevents adding support for severe overhangs and gives all pieces layer line strength. I used hex head button cap screws and provided wrench holes in the hook part for pass through tightening. For mounting holes snug screws down and let it set awhile and let the plastic settle, then snug down more. Too much at one time could cause the holes to split.

For the handle you need something thin to work the cap out. Take the screw out and push in the bushing. The handle screw hole is tapered and larger at the top and allows the handle to flop around. This remedies the problem and makes it feel nicer to crank the blade. A small amount of grease on the parts stops any squeak noises.

I used generic black PLA for the bushing and 0.10 layers; it still prints in minutes. The cord wraps I used 3D Fuel Lulzbot Green PLA, 0.20 layer, 3 walls, 25% infill.