14 Carrot Gold Ring
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Yup. I don't have a SLA printer nor smaller nozzles so it's a little rough looking but wearable.
- Rating
- 5 / 5
- Likes
- 21
- Downloads
- 74
- Makes
- 2
- Views
- 445
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Fashion Accessories
- License
- Creative Commons — Attribution — Noncommercial
Felt like making something silly. Wearable, surprisingly not as delicate as i thought.
Sliced in Cura, printed at .1mm layer height , 3 wall line count,
35mm/s print speed, .4mm line width,
Printing Temp 183C, Printing Temp Initial layer 195C, Z Hop When Retracted enabled
I only have a .4mm nozzle on my printer.
Base peels away with careful prying. There is a file without base support available.
Inner Diameter is about 14.234mm in the model, 14.3mm - 14.6mm after printing, a bit difficult to measure.
The roundness of the carrots makes it comfortable enough to wear, some sanding may be needed for the points and carrot tops depending on your printer.
Added gcode file for model with base, If you want to try. The model is not exactly centered because I wanted to avoid oozed bits left from the printer homing when it starts the print. I use a CR6 SE printer.