1 / 3
Fishing - Transmission Gear replacement for Okuma Coldwater reel - CW203D — image 1
1 / 3

Fishing - Transmission Gear replacement for Okuma Coldwater reel - CW203D

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Gear to bring a broken fishing reel back into service. Replaces stripped gear caused by frozen line winder guide

Rating
0 / 5
Likes
4
Downloads
21
Makes
0
Views
252
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

This is a fishing reel repair part for getting the line winder working on an Okuma Coldwater level wind reel - Model CW203D.

Okuma part #: 17070009

UPC#: 8400834225

Part name - Transmission gear.

This is a model for a temporary repair.  It doesn't mesh as gracefully as the original part that you can still order from Okuma.  But when you want some transmission gears to get your reel working for tomorrows fishing trip, this is the one for you.

After printing, the hole may be too tight (elephants foot).  I used a small file to rat it out a bit until it fit on the post.  A little grease and good to go.  The gears won't perfectly mesh when you re-install the side cap with the printed gear.  As you fit the cover on, you will need to roll the reel slowly to get the gears to mesh.  Then put the screws on and start slowly reeling.  You will find it feels “grainy” - as the metal gears teach the plastic (I used PETG for this reason) the shape they need to be.  After winding for 5 minutes or so it will loosen up.  After that, take the side cover off, clean off the gears and re-grease them.  Little bits of excess plastic from the “mesh” process will come off and the feel of the reel will improve.

It will never feel like the real factory molded gear, but if you have unfrozen the line winder guide and regreased it, this gear will get you going and last quite a bit.

How to print - top and bottom infill set to concentric, layer height .15mm structural (MK4s preset name), and 100% infill (rectilinear).  I recommend printing two at the same time to help with heat management on these small parts.

Tags