1 / 3
Embark Folding Chair Reinforced Joint and Foot — image 1
1 / 3

Embark Folding Chair Reinforced Joint and Foot

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Replacement parts for an Embark Folding Chair. These joints are designed beefier than the originals.

Rating
0 / 5
Likes
6
Downloads
32
Makes
0
Views
138
Reviews
0

Updated at source:

Model information

License
Creative Commons — Public Domain

These joints are reinforced but have NOT been long term tested. They may break again.

The Embark chair has 16mm diameter pipes.

These parts are uni-directional meaning a left foot will work as a right foot. The feet differ from the joints. The joints have through holes for the 16mm pipes whereas the feet are blocked. In other words, you'll only need the 2 models to replace all the joints/feet on your chair. I think, I didn't replace my front feed because they were not broken.

I used PETG with 6 walls at .2 layer height. But ASA would probably last longer.

Each feet and joint requires a 8-32 2-in and 1.25-in bolts and associated nyloc nuts. Each foot requires a short set screw so that the leg does not pull out.

During repair, you'll need to drill out existing rivets. It is recommended you replace the joints before the feet. Also repair one joint/foot at at time. If you pull off all the old joints/feet at one time, you'll have a mess of pipes on your hands. It'll be difficult to reassemble.

Good luck!