LilyGo T3 S3 Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A small and simple enclosure for the LilyGo T3 S3 LoRa development board
- Rating
- 4.5 / 5
- Likes
- 8
- Downloads
- 260
- Makes
- 1
- Views
- 1,814
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Share Alike
Overview
This is a simple enclosure for the LilyGo T3 S3 development board. The T3 S3 is fairly inexpensive and popular ESP32 board with an onboard LoRa transceiver.
Printing
There's not much to worry about printing this model. The .3mf file includes both halves of the clamshell. Print the top face-down and the bottom as it is oriented in the file.
Assembly
You'll need some hardware to assemble the case.
I used generic stuff I had purchased in a kit a while ago. There is a quite a bit of wiggle room on the length of the screws and inserts.
To assemble,
- Carefully set the four threaded inserts into the lower half of the case
- Line up the board on with the holes on the top part of the case, ensuring the the USB-C port is seated.
- Close the case and install the four screws.