Jetbeam E26 Cover (18650 Mod)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Provides clearance for an 18650 battery to be installed
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 56
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution
PETG or ASA recommended for higher heat resistance.
Supports required
The two rear screws need to be shortened 2mm or buy some the same as the front.
The clip can't be used
Use adaptive layers for best results on the curved surface
Note: This has been sized to fit the battery I installed with the electrical tape I wrapped around it, it's not a flush fit without it. Feel free to request alteration if needed.
The factory metal cover isn't glued, it only has adhesive, so use a heat gun to soften it.
I used isopropyl alcohol to loosen the adhesive on the battery, I made the mistake of tilting it forwards and the liquid ran through into the laser module, works still but looks bad. Don't do this.