1 / 2
Sturdy Little Hook w/ open top area
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Sturdy Little Hook w/ open top area
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 19
- Makes
- 0
- Views
- 57
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Garage
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
31mm tall x 26mm deep x 12mm wide
Needed a hook to hang cables on between the hook and wall and so I designed this with the mounting tab on the bottom so I have more room on top with this sticking out the least amount possible.
Tapered and non tapered screw holes. Use #6 hardware. Tapered is fine just don't over tighten as it acts as a wedge under load to split the layers apart.
Print as oriented with 5 perimeters and at the high end of your filament temp range for best layer adhesion. Use organic supports. They remove quickly and cleanly.
