3/4” EMT Conduit Foot
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a minimalist “rubber” foot for for 3/4” EMT conduit. Printed in TPU, this simple object slips snugly over 3/4”…
- Rating
- 5 / 5
- Likes
- 9
- Downloads
- 34
- Makes
- 1
- Views
- 106
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
This is a minimalist “rubber” foot for for 3/4” EMT conduit. Printed in TPU, this simple object slips snugly over 3/4” EMT. It also works if the conduit is already covered with a layer of heat shrink.
My hope is that TPU will last a little longer than natural rubber does in an outdoor environment. Real rubber feet are great, but the effects of hot, cold, rain, sun and ozone take a toll and they don’t last.
Print Settings
Printer:
Prusa Mini+
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
100
Notes:
You can adjust infill for the endcap section to suit your needs. For vertical support it makes sense to use 100%, at least where the conduit hits the inside base of the cap.
Designed this with TinkerCAD. First measurements were from a much larger rubber foot, but these stretch quite a bit, so my prototype proved to be too small to fit over the end of conduit.
The design also has two rings on the inside to add friction and make a better seal.
Category: Other