Case Insert for Tattu 3s-450mAh LiPo Battery
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holds the Tattu 3S 450mAh LiPo battery with XT-30 plug in its cardboard box better than the original insert.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 4
- Makes
- 0
- Views
- 70
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Share Alike
Following advice on transporting LiPo batteries, I have kept the original boxes they arrived in, but with the protective cover installed on the balance port, the batteries do not fit well in the original insert. I do not want the batteries to be loose in the box though, so I designed this new insert to keep the battery secure while also allowing room for the protective cover over the balance port.
TLDR: This keeps the battery secure in the box that the battery arrived in while allowing more room than the original insert for battery.
Disclaimer: LiPo batteries are dangerous and should always be handled with care and respect. I do not take responsibility for anything happening to your LiPo battery or any damage that it may cause.
This was specifically designed for the Tattu 3S 450mAh 75C LiPo battery with an XT-30 plug. I cannot guarantee that it will fit other LiPo batteries.
This is not meant to replace the original cardboard box. This is only meant to replace the insert that held the battery inside the cardboard box.
Print settings (default unless listed here):
Layer Height: 0.28mm DRAFT
Printer: Prusa MK4S
Preset: Overture PETG
Material: Overture PETG
I have also listed the STEP file if you wish to edit it.