Tamiya TA01 TA02 DF01 Front Gear Cover
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Front gear cover for Tamiya TA01 TA02 DF01 Chassis RC Cars
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 67
- Makes
- 0
- Views
- 264
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
Front gear cover for Tamiya TA01 TA02 DF01 Chassis
Tested quite thoroughly in a Top force evo to ensure it fits properly flush with the front gear housing, bearings will sit into place and that there is no interference with the gears.
The original hinge pin mounts only had two thin fins as support, this has been redesigned with thicker and more reinforced hinge pin mounts.
Reinforced version :
Thicker hinge pin mounts and the walls and the ribs are also thicker
Ideally printed in ABS, but PETG might be strong enough.
Due to the complexity supports are going to be needed. If printing in PETG, PLA can be used for the support interface.
Otherwise this may also be good for ABS like tough resin prints.
Reaming the hole for the hinge pin with 3mm reamer or drill bit should help the U pin slide in easier.